上圖為2015年新版三眼獸(柚木)
下面示範相機為2013年的舊版三眼獸 Presentation with 2013 old version "Natasha 3" camera
訂價: 4800元(不分木頭種類) price: US$170
相機尺寸: 高9.6公分(含旋鈕), 寬20公分, 厚4.5公分
Camera size: Height 9.6cm (included knob), Width 20cm, Depth 4.5cm
介紹 introduction
當打開相機背板, 會看到有三小塊木頭隔板
When you open the camera back, there are three small wood panels.
拿開三片隔板, 就是一台612片幅針孔相機了
Remove all three panels, it becomes a 6x12 frame pinhole camera.
在這個模式時, 必須觀看標示6x12小紅窗來得知拍到第幾張照片了!
In this mode, you need to see the 6x12 small red window the know which number of film you are going to take.
這時打開中央的快門, 就可以得到一張6x12照片
Open the center shutter, you can get a 6x12 frame photo
Example
但如果這時於兩個不同的地點打開兩側的快門, 就會得到以下的照片
but if you choose to open the shutters on the sides in different place, you would get pictures like below
Example
當然你也可以選擇在同一個地點打開兩側的快門
Of cause you also can open the shutters at the same time
把兩側的隔板插進插槽裡, 這時就變成一台6x9片幅針孔相機了! 在這個模式時, 只能打開中央的快門!
Put two side panels into the camera, you can get a 6x9 frame pinhole camera, but you can only open
the center shutter.
在這個模式時, 必須觀看標示6x9小紅窗來得知拍到第幾張照片了!
In this mode, you need to see the 6x9 small red window the know which number of film you are going to take.
Example
把中央的隔板插進插槽裡, 這時就變成一台有兩個6x6片幅針孔相機了! 在這個模式時, 不能打開中央的快門!
Put two side panels into the camera, you can get a double 6x6 frame pinhole camera, but you can not open
the center shutter.
你可以在不同地方打開快門, 得到的當然就是一張一張獨立的66片幅照片!
You can open the shutters in the different place to get individual 6x6 frame picture.
或者你也可以在同一個地方拍攝, 然後再用軟體把左右互調, 得到一個類3D的效果
Or you can shoot both 6x6 frame at the same time, and the use software to move the
left side picture to the right to get a 3D like picture.
注意: 在打開相機背板時, 只能由下方開啟, 若從上方開始時, 右側固定片軸的小板腳會被折斷
Caution: when opening the camera back, please open it from the bottom ! If you try to open it from the top,
the small board at the left side on the backboard would be broken.
留言列表
